Tuna Boat

[chadjans]

General:
Speed Bleeders
FireStik II Four Foot CB Antenna
Radio Shack TRC-504 CB Radio
Kidde 10Lb CO2 Tank Holder
Studded Brake and Gas Pedals

Suspension and Steering:
Rubicon Express 4.5 Inch Front ZJ Springs
Teraflex 1.75 Inch Front Coil Spring Spacers
DJ Safety Front and Rear Limiting Straps
Bilstein 5150 12 Inch Travel Front Shocks
ADS Machine 16 Inch Travel, 2.5 Inch Body Remote Res Rear Coil Over Shocks
Blue Coil Brand Rear Coil Springs

Drive Train:
1979 Ford Front Dana 60
1978 GMC Sierra Grande 14 Bolt Corporate Rear Axle
Alloy USA 35 Spline Inner and Outer Axle Shafts
Polyperformance Front Driveline Slugs
ARB Front Air Locker
Welded Rear Locker
Yukon Gear and Axle 5.38 Ring And Pinon Gears


Wheels and Tires:
Hummer H1 Wheels with MadMac Stamped Centers, MadMac Cold Rolled Inner Stiffening Rings and Copperhead Fabrication Rock Rings
39.5 Interco Bias Ply IROK Tires

Engine:
MSD Super Conductor Plug Wires
Borla Exhaust Header
Magnaflow 4 Inch Round Aluminized Muffler
Car Sound Direct Fit Cat
High Clearance Tail Pipe

KevinsJeepParts.com:
Modified ZJ-LP1 Rock Sliderz
Modified Lower Radiator Support

LoneStar Design and Fabrication:
Front Bumper with 2 Inch Receiver, Winch Mount and Stinger
Front Four Link Long Control Arms
Rear Triangulated Four Link Long Control Arms
Long Arm Frame Rail Sleeves
CO2 Tank Holder Bracket
Eight Point Internal Roll Cage with Frame Rail Tie Ins
Flat Transfer Case and Transmission Skid Plate
Rear Storage / Cargo Basket
Rear Frame Rail Bobbing and Reinforcement

[nathan]

did you leave anything off the list? what kind of air is in your tires?

[OverkillZJ]

did you leave anything off the list? what kind of air is in your tires?

LOL, I don't even know what all's on my jeep any more.

Great pics Chad! You forgot to mention "custom parking lot repaired front spider gears"

Is that "flip open tool box" mounted/built in? If so any pics?

How do you like the speed bleeders?

[chadjans]

...

[chadjans]

Great pics Chad! You forgot to mention "custom parking lot repaired front spider gears"

Is that "flip open tool box" mounted/built in? If so any pics?

How do you like the speed bleeders?

And side gears.

The tool box, I just finished. Alhough it was a project I didn't take any pictures of. I'll get some finished ones.

Speed bleaders are super nice. Open valves, push pedal and close valve. No open close crap.

Chad

[BigDaveZJ]

it was a project I didn't take any pictures of.

:shock:

Holy crap!!! I thought the ground felt kinda chilly today!!!

[OverkillZJ]

it was a project I didn't take any pictures of.

:shock:

Holy crap!!! I thought the ground felt kinda chilly today!!!

Are you implying that he's a picture whore?

Naaaaa.... :twisted:

[GetoZJ]

did you leave anything off the list? what kind of air is in your tires?

Can I get the serial numbers for all your parts? Maybe build dates, and the UPC's off the boxes

[nathan]

nice sig kelly

[nathan]

General
Speed Bleeders
FireStik II Four Foot CB Antenna
Studded Brake and Gas Pedals

Engine
High Clearance Tail Pipe


LoneStar Design and Fabrication:
Rear Bump Stop Extensions

you gotta admit some of that is just funny

[chadjans]

...

[Jim311]

I don't have any bumpstops


:lol:

[nathan]

Speed bleeders: someone asked about them
Cb antenna: need to have one
Studded pedals: Idea came from Pirate, how hardcore

Tail pipe: look at the last picture, see how high it is?


Bump stop extensions: need to have them from destroying shocks

Sorry I am not as hardcore as you. Why don't you look at your aviatar

my avatar is fine, they're called women, try and meet some sometime.

i was just pokin' fun of you a little, grow some thicker skin man. remember it's just the internet :P
i never said i was hardcore i just thought it was funny how you listed everything you did to your jeep. i never said that you didn't need some or all of it.
nathan

[GetoZJ]

Speed bleeders: someone asked about them
Cb antenna: need to have one
Studded pedals: Idea came from Pirate, how hardcore

Tail pipe: look at the last picture, see how high it is?


Bump stop extensions: need to have them from destroying shocks

Sorry I am not as hardcore as you. Why don't you look at your aviatar

my avatar is fine, they're called women, try and meet some sometime.

i was just pokin' fun of you a little, grow some thicker skin man. remember it's just the internet :P
i never said i was hardcore i just thought it was funny how you listed everything you did to your jeep. i never said that you didn't need some or all of it.
nathan

[chadjans]

...

[GetoZJ]

See Risko's avitar

[BMRisko]

See Risko's avitar

[chadjans]

...

[chadjans]

Made from 1/2 inch MDF and bolted to the roll cage with four 1by1by1/8 feet with 1.5 exhaust clamps.
Chad

[bigrubbers4x4]

that has to be about he ugliest colored interior i think i have ever seen in a grand. other than that its a real nice jeep man, keep up the good work, and keep the rubber side down.

[Kraqa]

man you would really think people would be used to his interior. i think thats sweet. good looking cage. how do you like the seats?

[chadjans]

man you would really think people would be used to his interior. i think thats sweet. good looking cage. how do you like the seats?

People are .... Thanks, Seats are okay. I am about to put in three prp seats.

Chad

[Nordic1]

great now I'm colorblind

ever consider using a color thats not red? :lol:

[chadjans]

great now I'm colorblind

ever consider using a color thats not red? :lol:

Great fantastic. Glad to see people focus on the wal-mart red paint and not the cage that took 64 hours to build and 6 21 feet sticks of dom tube to build.

[Swamp boy]

I have liked that since the first time I saw it. .Great work..

3 Seats.. Are you centering one in the back??? Thats actually what I was planning on doing..

I was going to take out the seats and cover the entire floor with a panel and put in just a single seat in the back.. My daughter rides with me and I want to do what I can to make sure she is safe...



OH yeah... I like the red.. :lol: :lol: