|
Built NP242 HD transfter case $400
1-1/4 wide chain and sprockets, 6-gear planetary, from Hummer/AMG tcase, but case is from a 242 J, so it has all the typical gear selections.
SYE with 32 spline output shaft (flange style)
Includes flange style end for drive shaft
Which SYE did you use?
It was a custom job, basically a heavy duty hack&tap:
- Started with a 32-spline flanged slip yoke, shortened it and machined it for the pilot diameter and bolt pattern of a 1310 DC joint. Like this, modified to match this.
- Shortened the tail cone machined it to accept a new seal to fit the new output flange.
- Shortened the output shaft and drilled/tapped the end to retain the output flange.
« Previous Thread | Next Thread » |
Thread Information |
Users Browsing this ThreadThere are currently 1 users browsing this thread. (0 members and 1 guests) |