|
Just finished wiring up my winch and wanted to add in cab controls using the pendant switch that came with it. I figure it's safer operating the winch from the cab and wanted to make something better looking than a hand held control hanging out of my dash.
The pendant control I had was just a simple momentary 3 pole switch were the middle wire was hot and the outer two wires energized the motor one way or the other. I took that switch out of the pendant and mounted it in the panel under my gauge cluster.
On the off chance this switch ever fails closed in either direction I wanted some sort of disconnect on the hot wire. I put a guarded toggle switch in line with the hot lead and mounted that in the same panel.
This will serve as a sort of on/off switch for the control.
Here's a shot of it all installed
Sent from my SAMSUNG-SM-G900A using Tapatalk
I used the existing hole in the firewall behind the evap box to run my cable
Sent from my SAMSUNG-SM-G900A using Tapatalk
Looks good! Also, good idea on running that master switch in line between the battery and toggle. I doubt I would have thought of that! Excellent - good job.
Clean! This has been on my todo list for years!!
« Previous Thread | Next Thread » |
Thread Information |
Users Browsing this ThreadThere are currently 1 users browsing this thread. (0 members and 1 guests) |