Thread: Anybody here know CAM, or CNC for plasmas?

Results 1 to 3 of 3
  1. #1 Anybody here know CAM, or CNC for plasmas? 
    Senior Member
    Join Date
    Dec 2007
    Location
    Colorado
    Posts
    949
    Rep Power
    103
    Having a fucking terrible time with my table. Absolutely at wits end with this shady goddamn company I bought my electronics package from, but that's another story.

    FINALLY got it cutting, but something still isn't right. The tip drags for the first inch, causing bad beveling and resolution, then the DTHC kicks in and lifts to the correct height, and finished the cut flawlessly.

    Using Sheetcam, and MAch3.

    Anybody familiar? The support forum gets major views, but zero posts.
    Last edited by FortCollinsZJ; 06-10-2014 at 07:46 PM.
    Neil R.

    93 318 ZJ, HP30, 8.8, 4.56, 35"s, tube.

    Quote Originally Posted by SirFuego View Post
    WTF? A unibody won? Did they build a mall at the finish line or something?


    Funniest thread on MC
    Reply With Quote  
     

  2. #2 Re: Anybody here know CAM, or CNC for plasmas? 
    Senior Member SuicideTireZJ's Avatar
    Join Date
    Nov 2004
    Location
    The drinking town with a college problem
    Posts
    1,145
    Rep Power
    101
    I know a bit of G and M code, post up the first few lines of the machine code that SheetCAM spits out if you can.
    Poetry in commotion.
    Reply With Quote  
     

  3. #3 Re: Anybody here know CAM, or CNC for plasmas? 
    Junior Member
    Join Date
    May 2015
    Location
    Buckeye AZ
    Posts
    13
    Rep Power
    0
    Sounds like a height control adjustment.. Can you adjust the voltage?
    Reply With Quote  
     

Thread Information
Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •