|
Having a fucking terrible time with my table. Absolutely at wits end with this shady goddamn company I bought my electronics package from, but that's another story.
FINALLY got it cutting, but something still isn't right. The tip drags for the first inch, causing bad beveling and resolution, then the DTHC kicks in and lifts to the correct height, and finished the cut flawlessly.
Using Sheetcam, and MAch3.
Anybody familiar? The support forum gets major views, but zero posts.
Last edited by FortCollinsZJ; 06-10-2014 at 07:46 PM.
Sounds like a height control adjustment.. Can you adjust the voltage?
« Previous Thread | Next Thread » |
Thread Information |
Users Browsing this ThreadThere are currently 1 users browsing this thread. (0 members and 1 guests) |