Thread: New springs comin

Page 3 of 3 FirstFirst 123
Results 51 to 56 of 56
  1. #51 Re: New springs comin 
    Senior Member
    Join Date
    Feb 2011
    Location
    New Hampshire
    Posts
    345
    Rep Power
    57
    Yes the vibes started right after the lift was installed. I could prob locate an angle finder at a local harbor freight? As for the U-Joints in the rear DS, there isnt any "play or slop" but I do have almost 260K on the original units
    Brian
    1aauto.com
    866-433-3393
    Jeep Repair Parts
    Reply With Quote  
     

  2. #52 Re: New springs comin 
    Senior Member
    Join Date
    Feb 2011
    Location
    New Hampshire
    Posts
    345
    Rep Power
    57
    Thanks guys for all your help. Ive done a ton of repairs on all kinds of stuff and this is driving me nuts. All your help is much appreciated!!
    Brian
    1aauto.com
    866-433-3393
    Jeep Repair Parts
    Reply With Quote  
     

  3. #53 Re: New springs comin 
    Member
    Join Date
    Feb 2010
    Location
    cherry valley il
    Posts
    146
    Rep Power
    60
    angle finder can be found at any sears for about $10
    Reply With Quote  
     

  4. #54 Re: New springs comin 
    The class retard Lifetime Supporter ajmorell's Avatar
    Join Date
    Feb 2007
    Location
    Santa Fe, NM
    Posts
    1,525
    Rep Power
    96
    Crap, I forgot to see if I still had those spacers. I'll write myself a note so that I remember to do it tonight.
    Reply With Quote  
     

  5. #55 Re: New springs comin 
    Senior Member
    Join Date
    Feb 2011
    Location
    New Hampshire
    Posts
    345
    Rep Power
    57
    So its been a while, I simply welded in a 1" piece of square stock for the t-case bracket and all driveline vibes gone. Still trying to tweak out the DW but drives SOOO much more smooth.
    Brian
    1aauto.com
    866-433-3393
    Jeep Repair Parts
    Reply With Quote  
     

  6. #56 Re: New springs comin 
    Senior Member
    Join Date
    Feb 2011
    Location
    New Hampshire
    Posts
    345
    Rep Power
    57
    Just as an update, I replaced both driver and pass wheel. Pitman arm tie rod end and driver tie rod end. The tie rods were not sloppy when on the vehicle and tested as we normally do. I replaced them with the hubs JIC. Steering is much tighter.
    Brian
    1aauto.com
    866-433-3393
    Jeep Repair Parts
    Reply With Quote  
     

Page 3 of 3 FirstFirst 123
Thread Information
Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •