|
Anyone running an Addco with JKS disco's?
The Addco's have the holes for the end links 908 from the stock location and I remember seeing something about an adapter kit or something for the JKS's if you are running an Addco, but can't find anything on their site.
So thought I would ask here first and then start calling around if I can't find anything.
Let me know.
Thanks.
I'm running an addco bar with JKS disco's. I did some shaving of the bar. In a bit I'll go take some photos and show ya what I did.
Right-O 'ol chap. What you see is actually a funny story of me NOT paying attention to detail. I bought the ZJ Addco front bar from Addco of course and the ZJ JKS Disco's from Kevin's. The JKS Disco's stated that these will NOT work with after market sway bars. When the Addco bar arrived I was dismayed to see that the ends are ROUNDED. This is why the Disco's would not bolt right up.
Not a problem! I whipped out the grinding wheel and went to town making sparks fly. I was also carefull NOT to grind continuoisly for fear of extrem heat causing warpage. Within a few minutes off and on I had the ends carefully squared off enough for the Disco's to mount up without trouble.
Now I just need to get off my lazy ass and paint them black again to stop rust from forming.
Also thanks for giving me an excuse to whip out my camera and my flashes. I have 3 Canon 580EX II flashes but only used one for these photos.
ENJOY!
Last edited by zj-monster; 06-23-2009 at 08:21 PM.
True but I didn't have larger bolts, nuts, & washers to make that happen. The hole on the swaybar is a lot larger than the bracket hole, thus I would have had to drill the top end of the bracket to match. If not, I will have a LOT of play from the swaybar.
There's room for improvement but for the time being this holds up well.
You have the WJ Addco Bar. You're doing what Kevin mentions on his site. You'll just need to score TJ/ZJ JKS Disco's and also score an extra disco pin. I was gonna go in that direction until I pulled out the grinding wheel.
Last edited by zj-monster; 06-23-2009 at 09:10 PM.
Hmmm...you'll just need another set of bolts with pins. I'd give either Kevin or JKS a call and see if they have a solution.
Last edited by zj-monster; 06-23-2009 at 09:11 PM.
should try SwayLoc, It's stiffer than Addco on treet mode, take 1 second to disconnect or connect on not level ground. Plus the swayloc will not slide like Addco and causes rubbing issue. I ditch my addco already!
Fitch does not work at all, it's a scam!! it's now a extra piece of junk on my car.
« Previous Thread | Next Thread » |
Thread Information |
Users Browsing this ThreadThere are currently 1 users browsing this thread. (0 members and 1 guests) |