• MallCrawlin.com

    by Published on 04-13-2011 08:39 PM


    Welcome to MallCrawlin.com! MallCrawlin is your home on the internet for hardcore 4x4 tech. While our site focuses and really specializes in taking Grand Cherokees to the highest level of modification, we are really about modifying anything to make it more capable off-road. The site is absolutely geared towards those who have a good knowledge base already in place and are looking to expand on it. If the most hard-core action your rig has seen is the curb at the mall, we have a newbie area for you too, but if you ask the same old stupid questions that have plagued other Jeep forums over the years (what size tire I can fit, which budget boost is best, etc), you may not fit in here very well.

    If you are new to the site, you will also find that you are not able to start a post in the advanced tech sections of the site. You can certainly reply to an existing post, you just can't start a new one. This has been done to maintain the integrity and the level of discussion that our members (and myself) expect from this site. Once you reach a post count of 100 (chit chat posts do not count) you will automatically gain the ability to start threads in the advanced sections. MallCrawlin's staff reads almost every post out there, so if we see someone who is abusing this, action will be taken. On the flip side, if we notice someone with a level of technical knowledge obviously above the Newbie Tech forum, we will go ahead and waive the restrictions for that person.

    Thanks for visiting MallCrawlin!
    by Published on 04-02-2011 10:01 PM

    You guys have been asking for it forever, and now it's here! Check it on the main forum directory page, or click ChatBox Full on the NavBar from the main directory page to check it out! ...

  • Recent Articles

  • Recent Forum Posts


    Daddy shark dododo rig

    My redneck engineered land based shark fishin 2wheeler

    Sent from my SM-A205U using Tapatalk

    Ccole1494 01-20-2020, 03:01 PM Go to last post

    Re: Project Hugs Version 4.0

    Oh, and a rough measurement in my uneven driveway shows close to 3" of gained clearance at the rocker panel vs the factory pinch weld. I'll have

    Yjsaabman717 01-19-2020, 02:43 PM Go to last post

    Re: Project Hugs Version 4.0

    Do you have any pics of your pedal setup? Mine is, indeed, hitting the floor. But looking at things it almost looks like the XJ pedals are too long. Now,

    Yjsaabman717 01-19-2020, 02:29 PM Go to last post

    Re: Project Hugs Version 4.0

    Thanks for the tip. I'll check mine to see if it's hitting the floor, or not. The grinding occurs after a few shifts, notnall the time. That's why I'm

    Yjsaabman717 01-17-2020, 10:08 PM Go to last post

    Re: Project Hugs Version 4.0

    On my 5 speed ZJ I wad to put a slight bend in the clutch pedal to allow it to get full travel without the pedal bottoming out on the floor. After I did

    Gearjammer 01-17-2020, 09:50 PM Go to last post