• MallCrawlin now has a SHOUT BOX

    You guys have been asking for it forever, and now it's here! Check it on the main forum directory page, or click ChatBox Full on the NavBar from the main directory page to check it out!
    Comments 1 Comment
    1. CrawlerReady's Avatar
      CrawlerReady -
      Posting so I can see my new avatar again
  • Recent Articles

  • Recent Forum Posts

    91 Jeep Project

    Re: Project Red Velvet

    Wasn't really ready for axles but couldn't pass up the deal. 05+ Super Duty 60 and '08 GM 14 bolt (8x6.5), new unit bearings up front and I'll avoid the

    91 Jeep Project Yesterday, 10:14 PM Go to last post
    Yjsaabman717

    Re: Project Hugs Version 4.0

    Thanks for the input, I was looking into those. We have an account with Napa at work, and even at that cost they're a good bit more than the average ones

    Yjsaabman717 Yesterday, 08:22 PM Go to last post
    Ken L

    Re: Project Hugs Version 4.0

    The last time I did mine I used NAPA. They have been decent for me. I just figure that they are going to wear out with the torque and flex that we subject

    Ken L Yesterday, 06:18 PM Go to last post
    Yjsaabman717

    Re: Project Hugs Version 4.0

    New OE mounts are NLA and aftermarket stock replacement are crap. I don't need Bomb Proof mounts, or even the poly inserts I've found. Is there any kind

    Yjsaabman717 10-20-2020, 07:25 PM Go to last post
    Yjsaabman717

    Re: Project Hugs Version 4.0

    So I noticed the other day when I was looking things over one of the engine mounts is torn. Cheap Anchor crap, these are only about 3 years old. So, any

    Yjsaabman717 10-19-2020, 05:49 AM Go to last post