• Recent Forum Posts

    BigDaveZJ

    Re: Project Red Roof Inn

    I figure even if 2 of the 3 attachment methods fail I'll still got one left holding it! lol

    BigDaveZJ Today, 02:47 PM Go to last post
    Ted_Z

    Re: Project Red Roof Inn

    Weld, sheet metal screws AND pop rivets! I like it. Throw some bubble gum on there too :O) Good job drilling relief holes at the end of the cracks.

    Ted_Z Today, 01:10 PM Go to last post
    Daves Offroad Supply

    Re: Daves Offroad Supply

    Daves Offroad Supply is an Artec Industries Dealer!
    Artec offers top of the line products that work and look amazing!


    From

    Daves Offroad Supply Today, 11:20 AM Go to last post
    BigDaveZJ

    Re: Project Red Roof Inn

    2 of 3 done. Used a similar method as when I welded the new roof on and that's held up so far so hopefully this will too.

    Sent from my Nexus

    BigDaveZJ Yesterday, 09:21 PM Go to last post
    BigDaveZJ

    Re: Project Red Roof Inn

    Current status of my unibody. Honestly surprised it's not worse all things considered. Debating on tacking the cracks AND plating it, or just plating

    BigDaveZJ 08-19-2017, 04:21 PM Go to last post