PDA

View Full Version : WIHA Nut, screw and torx drivers.



ProjectZJOM617T
09-04-2006, 08:27 PM
http://www.wihatools.com/images/Promo%20Images/September/09.380px.jpg

I just bought them in both SAE and MM...

I saw and tested a set at a lab where a friend is an engineer...

They are as good or IMHO better than MAC or snap on for alot less. I got both std and metric for ~$70 shipped.

I also got a set of these from sears.com $9.97

Like a ball type u-joint driver for phillips.. Vid demo
http://www.wihatools.com/Movies/Orbit/orbitalscrewing.htm

http://s7.sears.com/is/image/Sears/00973674000

Next up is replacing all my crapsman and rust stainley phillips, slot and torx crap with a full set of the WIHA's.....

Then eventually getting this driver a friend in avionics has...

http://s7.sears.com/is/image/Sears/00950481000http://www.wihatools.com/images/TorqueTools/scale.jpg

I have found different deals and specials around ebay, whia.com and sears.com... Excellent tools at a discount are always a good find...