Matt B
01-21-2006, 12:10 AM
Ok i have decided to rebuild my set up. I have built a long arm set up similar to Clayons, but just a little different crossmember. I am going to run coil overs and a 38" tire with dana 60s front and rear (full width), but I am not real sure where to start as far as length and valving of the coil overs. I have started the cage inside and was thinking that I would run the cage down to the rad. core support and attach the coil overs to that (the cage not the core support) and basically the same thing in the rear with a couple of mods to the geometry. so what do you think? any ideas?.........bash away if you would like,
thanks
thanks