matts96zj
01-19-2006, 04:47 AM
Ok, so im gonna truss my 9" using the same design as BTF:
http://www.bluetorchfab.com/oscomm/c...ana44truss.jpg
mine will obviously not have the diff cover reinforcement as there is no cover on the 9", but it will sit directly on top of the center section & be welded there. Do you guys think 3/8" plate will be heavy enough to support my traingulated uppers??? The BTF one uses 1/2". I'll also be adding more supports out towards the ends of the tubes.
http://www.bluetorchfab.com/oscomm/c...ana44truss.jpg
mine will obviously not have the diff cover reinforcement as there is no cover on the 9", but it will sit directly on top of the center section & be welded there. Do you guys think 3/8" plate will be heavy enough to support my traingulated uppers??? The BTF one uses 1/2". I'll also be adding more supports out towards the ends of the tubes.