PDA

View Full Version : RE 4.5 coil height?



BiggerZJ
12-07-2005, 05:18 PM
i need some help, if anyone has a zj with RE 4.5 coils i need to know the coil height under vehicle weight both front and rear. i had the measurements from the ones in the jeep we are working on but the roof on our shop decided not to hold out rain water and my notes are destroyed. this zj has the 4.0 and an arb with 9000 winch in it, so someone with close to the same setup would really help.

jeepnzj1
12-07-2005, 06:09 PM
mines 5.2 arb and no winch front 15 1/4 to 15 1/2 rear stock bumper w hitch 12 1/2 12 3/4'' ground is not perfect so each wheel was a tad different hope this helps /Kevin/

BiggerZJ
12-07-2005, 09:55 PM
u are a life saver!!! thanks man

MikeyM
01-04-2006, 04:15 AM
mines 5.2 arb and no winch front 15 1/4 to 15 1/2 rear stock bumper w hitch 12 1/2 12 3/4'' ground is not perfect so each wheel was a tad different hope this helps /Kevin/

Hey jeepnzj, whats the measurement from the center of your front and rear hubs to the fender?

Thanks, Mike

jeepnzj1
01-04-2006, 01:12 PM
hard to tell ill go measure it right know for you but my front fenders are trimmed about 5/8 to an 1" front from bottom of fender to center of hub is 25 1/2 rear is still not trimmed and it sits at 23 1/8 hope this helps im on 33s

BlackDiamondBound
01-04-2006, 09:58 PM
any reason why the rear sits so much lower? its the same way with/ my jeep.

1 BAD ZJ
01-04-2006, 10:09 PM
When you figure out why ZJs sit lower in the rear let me know. Mine does the same thing with kevins 7" springs.

2jeepsforus
01-04-2006, 10:42 PM
Your jeeps have ghetto booty.. thats all

Motion to get a smiley that has ghetto booty, that shakes it like a salt shaker :eek:

outsider
01-05-2006, 08:50 AM
any reason why the rear sits so much lower? its the same way with/ my jeep.

look at the fender front and rear. the front cutout is an inch higher than the rear. measure the pinch weld just in front of the rear tire and just behind the front tire. that will tell you if it is level.