PDA

View Full Version : 242 TC binding - Need Help



Kcolg
08-26-2005, 09:39 PM
I have a 1994 ZJ with 42re and 242 TC, RE 4.5" lift. I just installed an Aussie locker in the front D30 last night (already have one in the rear), anyway the locker works fine other than it is a little louder than what I expected from others that have posted about them.

My problem is I now have a light grinding sound (like a binding) when I put the vehicle into gear (forward or reverse). I pin-pointed it down to I believe the 242 TC. I know I can not use Fulltime with a front locker, however it makes the noise whether I am in 2wd or Part Time 4 WD. I am guessing this is not good. Anyone have any ideas. No problems before the locker install, just started right after.

Need help desperately.

OverkillZJ
08-26-2005, 10:22 PM
If it happens in 2wd, somethings probably wrong. 4wd (even full time) will bind with a locker in the front nomatter what. I haven't played with an Aussie yet, so can't say for sure though.