PDA

View Full Version : 249 to 231 swap question



bruce
05-23-2005, 09:17 PM
Anyone know the part number I need for the input seal/bearing on the 231. The old seal on the 231 is too deep/thick, not allowing the input shaft to fully "stick out" .

I am in the middle of the swap and this is the only thing holding me up.

249 is 52098539
231 is 52097890

Guess I could take the one of the 249 and put it on the 231?

Thanks in advance.

nate
05-24-2005, 04:39 AM
Hmm, not sure. But, you should have a year on the T Case, and probably could figure out what it came out of, so that might work out at Napa or wherever.

OverkillZJ
05-24-2005, 11:14 AM
Ya, Napa's been very helfpul in hunting down seals and such like that with me, as long as I get them a vehicle year and what transfer case it was. Just find someone very patient behind the parts counter :rock:

Oh and JBconversions is sometimes willing to help too, even if you don't give them any business.

bruce
05-24-2005, 09:08 PM
thanks guys,,,used the bearing/seal off of the 249 workd like a charm,,,all back together now,,,ready to install tomorrow night