View Full Version : Rear driveshaft options, to short? 7"lift/ford 8.8
Hkoch45
05-16-2005, 07:58 AM
Just got done installing 7" lift with LA's and installed at same time ford 8.8 axle. Pinion angle 11 degrees and 242np transfer. My question is do you goes run a cv rear driveshaft, or lengthen the stock driveshaft, or whats my other options. Cause even with the ford yoke adaptor my driveshaft is 2.5"-3" short. The driveshaft hardly reaches the slip yoke. Let me know what you guys think.
KevinM
05-16-2005, 10:59 AM
Two easy steps to solve the driveshaft issue:
1) measure from the t case yoke to the axle yoke
2) call Tom Woods
MaineZJ
05-16-2005, 01:18 PM
SYE the 242 and try a stock ford explorer shaft.
or call High Angle driveline :mrgreen:
Just brought mine into today, 40" from yoke to flange.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.