View Full Version : onboard pressure 110-150
scubatch2
03-29-2005, 03:10 AM
I just installed viairs onboard air.I thought they were sending me one w/ a 85-110 regulator but in was a 110-150.What are the draw backs if anyn for it being higher.is that a little high for most air tools or am I OK like that.
Just use a regulator. On my OBA setup, the tank is at 150, and the regulator is at 90.
Kraqa
03-29-2005, 03:22 PM
if you run your tank at a higher pressur then when you use it you will have more time before your compressor need to turn on. 90-150 is what i run and i like it.
Nordic1
03-29-2005, 06:12 PM
if you run your tank at a higher pressur then when you use it you will have more time before your compressor need to turn on.
That and it takes longer to fill to a higher PSI with crappy air compressors. That and you'll need a reg if you want to run air lockers or some air tools.
Which Viair did you get?
PassRunnerZJ
03-29-2005, 08:50 PM
If you run an ARB keep it below 110 psi. ARB recommends 95 psi, but they are supposed to work from 60 - 110 psi.
scubatch2
03-29-2005, 11:58 PM
Which Viair did you get?[/quote]
I got the 400,if I was to switch to the 90-110 pressure switch then I will not need a regulator to run air tools ,correct?
Yup. The thing with that though is it won't take long at all before the compressor kicks on. I have a 2 gallon tank and the Extreme Aire compressor. Takes about 3 mins to fill it to 150psi.
Kraqa
03-30-2005, 04:10 PM
a regulator only cost 10$ and it is a usfull tool. I would get one. some tools run at 75 PSI and some run at 110.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.