View Full Version : 23 spline transfercase input shaft, early gear cut
rccolacc
03-23-2005, 08:05 PM
I need an early gear cut (pre '95) style 23 spline transfer case input shaft. It has to be long length, but the bearing style (narrow or wide) does not matter.
I am gathering the pieces together to do an '88 231 swap into my '97 grand.
Thanks.
-RC
rccolacc
03-23-2005, 08:43 PM
I forgot to put a link to this:
http://www.novak-adapt.com/catalog/231_input_gears.htm
It shows the shafts and what the difference is pretty well.
Thanks again.
-RC
Nordic1
03-23-2005, 09:47 PM
pre 95? I think Dirk CueBall has one... I say that because I just shipped him my 96+ input shaft
Cue-Ball
03-24-2005, 01:18 AM
... I just shipped him my 96+ input shaft
You must have shipped it via pony express through Arizona or something since I still have not received it. Damn I could have walked to your place and picked it up by now. :mrgreen:
rccolacc
03-27-2005, 11:41 AM
Ok, I sent an email to Dirk. He said it will be some time before he pulls his 249 and the 242 he has laying around is a 21 spline input. Anyone else have a 23 spline early gear cut input shaft? Anyone know where else I should look for one?
Thanks.
-RC
I have one but I htink it's the medium lenght.
2.125" length from surface when in the case
Cody
rccolacc
04-16-2005, 06:18 PM
Sent Cody a PM.
Thanks.
-RC
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.