PDA

View Full Version : 96 grand swap in t-case and or diff's



lumpybluezj
03-04-2005, 01:18 AM
I have been looking for diff.s to upgrade 96 zj...I have found a 81 powerwagon 3/4 ton for free.

the pick-up has front diff. with the wrong side drive shaft, I was going to start to cut tubes and re-weld them to correct the problem but I got a thought

the transfer case in the truck has no numbers on it but it has a PTO on it.so I don't know for sure what it is but either a np205 or 208

the zj has a t-case that only has 4h-n-4l doesn't slip in low range but high range doesn't alow much torque to front axel.

I am thinking maybe i should just swap the transfer case with the diff.s but i don't know if the t-case will bolt onto the transmition?
also what size diff.s would normally be in a '81 power wagon 3/4 ton?

Raacerx
03-04-2005, 02:05 AM
Why would you deal with all the fabrication when there are far easier solutions?

Kraqa
03-04-2005, 02:11 AM
lol bye raaser's axles







hmm you can bolt that up it will mostlikly require a expensive adapter. then you need to deal with the floor board issue.