PDA

View Full Version : Sway bar end link length



MaxC
02-28-2005, 06:01 PM
I am going to change my steering setup and need to raise my sway bar end like mounts on the axle. Is it ok to only raise the passanger side mount and leave the drivers alone? I have JKS disconnects with easily enough adjustment but I don't know what this will do to my handling. Can you have different length endlinks and sway bar mounts on either side of the axle? Has anyone tried this? I am freaking lazy I know. I should just cut them both off and weld on new ones but I don't want to if I don't have to.
Max

OverkillZJ
02-28-2005, 06:25 PM
I used to have the passengers side up 2" higher than the drivers side with JKS disco's, I had no issues at all.

Until I broke a mount, but that wasn't related.

BMRisko
02-28-2005, 06:35 PM
You will be fine as long as your swaybar is at roughly the same angle on both sides. Just adjust the links so they bolt in while the Jeep is sitting level. Sometimes one side of the Jeep is higher than the other due to spring sag, bow, trac-bar pull, etc.

MaxC
02-28-2005, 06:44 PM
Thanks for the Responses. Just wanted to make sure I wasn't doing anything stupid.
Max