PDA

View Full Version : Clocking Ring



MaineZJ
02-17-2005, 05:48 PM
OK, so Maine sucks for inspections of ABS equipted rigs...
Gonna swap out the 249 for a 231 shortly. I know someone who can make clocking rings at a decent price.

With 3" lift, would clocking the xfercase up some- would that create too much of a problem with the front driveshaft?
Thinking if I can clock it some, I can make a near flat belly skid.

Nordic1
02-17-2005, 07:01 PM
At 3", if you ran a dual cardigan (sp?) shaft, you should be fine... a clocked 231 would be cool

BigDaveZJ
02-17-2005, 07:29 PM
At 3", if you ran a dual cardigan (sp?) shaft, you should be fine... a clocked 231 would be cool

Two sweaters won't do shit for a driveshaft dumbass!!!!

Kraqa
02-17-2005, 08:38 PM
i don' think the 231 would be able to be clocked that much. there is only about 3/4" between the 231 and my floor boards.

Jim311
02-18-2005, 12:24 AM
At 3", if you ran a dual cardigan (sp?) shaft, you should be fine... a clocked 231 would be cool



Dual sweaters?



Or do you mean double cardan? :D

AprilzWarrior
02-18-2005, 12:43 AM
At 3", if you ran a dual cardigan (sp?) shaft, you should be fine... a clocked 231 would be cool


OWND by being a berkeley biatch...

MaineZJ
02-18-2005, 08:47 AM
i don' think the 231 would be able to be clocked that much. there is only about 3/4" between the 231 and my floor boards.

damn you, ruin my fun :flipoff:
oh well, I'll slap in the 231 and see where it lands

Kraqa
02-18-2005, 12:21 PM
pluss the tranny x-mamber comes below the t-case.