PDA

View Full Version : TD International Winches



Tommy
12-27-2004, 05:19 PM
Anybody ever heard of this winch company before. I know that you get what you pay for, it is only like $499.00.

http://images.overstock.com/f/102/3117/8h/www.overstock.com/images/products/P1008995.jpg


Rated line pull: 9,500 lbs. single line
Motor: 5.5 HP/4.0 kw series wound
Volt: 12V
Line speed: 7 ft./min. with load
Control: remote switch; 12 lead
Gear train: 3-stage planetary
Clutch: sliding ring gear
Brake: automatic in-the-drum
Drum size: 2.5 dia. x 9 in.
Wire rope: 90 ft. x 5/16 in. dia.
Fair lead: 4-way roller fair lead
Recommended battery: 650 cca
Battery leads: 2-gauge 72

robselina
12-27-2004, 10:35 PM
never heard of them but it sounds like a screamin' deal. What's the warranty?

Jim311
12-28-2004, 03:36 AM
7 foot per minute loaded?


:?

Tommy
12-28-2004, 10:28 AM
I would need to look into the warranty. This is offered on a website through my work. It has a whole bunch of stuff, from tools to home theater systems.

Tommy

robselina
12-28-2004, 10:31 AM
7 foot per minute loaded?


:?

LOL, yea, sure hope that's ft/sec....

Tommy
12-28-2004, 11:02 AM
Guys, that is the LOADED line speed (9,500 lb load i am assuming). The line speeds for the warns are not in ft/s either. unloaded line speds for the warns are as follows. The warn M8000 with a loaded line is rated at 8ft per min. 7 ft/min is not a bad loaded line speed. The question is what is the unloaded line speed? 7ft/min seems to an average loaded line speed.


http://www.jeep4x4center.com/tj/M827450.gif
M8274-50 no-load is now at 73.4 ft./minute, 150 ft. of 5/16"

Rated Line Pull: 8000 lbs. (3600 kgs.) single-line
Motor: 4.6 hp/3.43 kw, Series Wound
Control: Remote switch, 12' (3.7m) lead
Gear Train: Spur Gear
Gear Ratio: 134:1
Clutch (freespooling): Sliding Motor Pinion Gear
Brake: Automatic, disc type
Drum Diameter/Length: 3.5"/8.5" (9cm/22cm)
Weight: 110 lbs. (50 kgs.)
Wire Rope: 150' 5/16" diameter (46m, 8mm diameter)
Recommended Battery: 650 CCA minimum for winching
Finish: Argent Powder Coat with Clear Coat
Warranty: Limited Lifetime



http://www.jeep4x4center.com/tj/XD9000iWinch.jpgXD9000iNow, 4.6 hp Series Wound (tm) motor, No-load line speed is 38 ft./minute

Rated Line Pull: 9000 lbs. (4082.kgs) single-line.
Motor: 4.6 hp/3.43kw, Series Wound
Control: Remote switch, 12' (3.7m) lear
Gear Train: 3-Stage Planetary
Gear Ratio: 156:1
Clutch (freespooling): Sliding Ring Gear
Brake: Automatic Direct Drive Cone
Drum Diameter/Length: 2.5"/9.0" (6.4cm/23cm)
Weight: 85 lbs. (38.5 kgs.)
Wire Rope: 125', 5/16" diameter (38m, 8mm diameter)
Recommended Battery: 650 CCA minimum for winching
Finish: Argent Powder Coat
Warranty: Limited Lifetime




http://www.jeep4x4center.com/tj/M12000Winch.jpgWarn Winch M12000 24V no load retrieval speed is 30Ft. per minute low profile, design, 4.6hp series wound motor , three stage planetary gear train, 125 Ft. of 3/8" wire rope)



http://www.jeep4x4center.com/tj/platinum.jpg
35.4 Ft. per min. no load 7.87 Ft. per min. full load line speed, limited lifetime warranty)

Tommy
12-28-2004, 11:10 AM
It only has 90 ft of cable, and the warn has 125 ft.

gearhead313
12-28-2004, 04:07 PM
Looks like a warn knock off to me.. sorta like the Magnum 9k winch.

If the warrenty is anywhere near decent, then sounds like a good deal



...and 7ft/min. pullin 9.5k is freakin gettin some. Thats better than the winch STOPPING at 9.5k!!