MaineZJ
10-31-2004, 12:51 PM
OK, this is really pissing me off. trying to pull my xfer case to change some seals.
I can get all the nuts off (including the stupid top one), shafts out, wires/hoses off. should be all set to pop right out.... nope...
That top stud I'm thinking has some corrision on it (washer was toast) and it's not pulling out of the tranny.. I've done everything I can think of to get it to move, used shims midway up the case to try and pivot down on, hitting anywhere I can without cracking the case....
Anyone have any ideas on getting this to release?
I can get all the nuts off (including the stupid top one), shafts out, wires/hoses off. should be all set to pop right out.... nope...
That top stud I'm thinking has some corrision on it (washer was toast) and it's not pulling out of the tranny.. I've done everything I can think of to get it to move, used shims midway up the case to try and pivot down on, hitting anywhere I can without cracking the case....
Anyone have any ideas on getting this to release?