View Full Version : Need Ideas for Crossmember
Mine is so smashed up, I need to make a new one before I go to the badlands on the 30th of this month. I am going to tackle the project this weekend.
For those of you that have made one, or have a non-factory one on there, can you post a pic or two and maybe give me a couple pointers or things you'd recommend that I do.
Thanks!
LouisianaZJ
10-19-2004, 03:45 PM
look at www.kevinsoffroad.com for some pics of his
I sleeved my frame rail. In effect I did away with the need for the bolts that go into the frame rail.
http://smallnet.homeip.net/gallery/albums/Long-Arm-Build-Axle-Upgrades/IM000818_JPG.jpg
JeepinHank
10-22-2004, 10:12 AM
2x4x3/16" rectangular tubing.
Cut to length, Make 45* cuts on the end so you can get the bolts in & out, cut for clearance on the front driveshaft (maybe rear), and cut out the oval/drill holes in the center for the T-case mount. Then drill out the holes to mount the x-member to the frame.
I want to do this, but can't find any 2x4x3/16 at my local steel dumpster. (I know I need better sources :roll: ) I can't just go and buy a 3 or 4 foot piece, cause my suppliers don't keep it in stock, and won't order a whole piece for me to buy 3 or 4 feet. I got some 2x4x0.25, but IMO, that's too thick.
A hole saw would probably make the circular cut-out a lot easier. Other than that, a drill, chop saw, grinder and some cutting wheels, and you're in business.
Nordic1
10-22-2004, 02:31 PM
sell it on JU for a million dollars
Thanks for the help.....I think I have an idea of where to start and the little bit of redneck in me, and ghetto engineering that i seem to be good at may lead to a completed crossmember that will work if i'm lucky.
I'll post pics when i'm done!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.