PDA

View Full Version : Radius Arm Lengths



Jcbzj
10-19-2004, 03:01 PM
I just picked up some Front TJ Lower longarms (RE) for really cheap. If I run them at about 36", how long do you think my uppers need to be (radius style). Im trying to figure out if I can run some of these CA's I have sitting around. I also need a picture showing the unibody brackets for the RE longarm because Im going to have to come up with something for that as well. I search but I didnt find any specific lengths.

Also, should I run just one radius arm to prevent spinning an axle tube? Ive heard both sides of this argument, but have never had any experience with it.

OverkillZJ
10-22-2004, 12:11 AM
Honestly, input from other peoples lengths may be useless... Get under your rig with measuring tape and paper. Then get under there later with a welder :)

1 vs 2 uppers? I've run both... 1 = better flex, but almost tended to unload too easily.