JeepinHank
07-28-2004, 03:38 PM
Hey everyone. I just left an auto shop, and I happened to mention that I was looking for an axle.
Long story short - One of the guys in there said his father has a wrecked 77 Ford crew cab sitting at his house. He said it was a F100, but I don't think I agree because of what he said was in it. Specs that I know of: 460 engine and 4 wheel drive. Thats all I've got until I get a chance to talk to the guy's father.
The best I can figure is that its either an F-150 or F-250 crew cab. It was a work truck for the guy's roofing company.
If so, it SHOULD have a nice HP dana 44 up front (flat top knuckles, etc) and a big bearing 9" rear end.
Can anybody add to or correct what I know (or think I know)? I figure one of you guys has at least come across one of these trucks, or actually swapped a set of these axles.
I'd really like to know what the other specs are, Trans, t-case, etc.
I can probably get the entire vehicle for around $500, and if I can sell off some of the other parts and make a little money back - I could get these axles pretty cheap.
Thanks all!
Hank
Of course - I'll try to provide any other information as I get it.
Long story short - One of the guys in there said his father has a wrecked 77 Ford crew cab sitting at his house. He said it was a F100, but I don't think I agree because of what he said was in it. Specs that I know of: 460 engine and 4 wheel drive. Thats all I've got until I get a chance to talk to the guy's father.
The best I can figure is that its either an F-150 or F-250 crew cab. It was a work truck for the guy's roofing company.
If so, it SHOULD have a nice HP dana 44 up front (flat top knuckles, etc) and a big bearing 9" rear end.
Can anybody add to or correct what I know (or think I know)? I figure one of you guys has at least come across one of these trucks, or actually swapped a set of these axles.
I'd really like to know what the other specs are, Trans, t-case, etc.
I can probably get the entire vehicle for around $500, and if I can sell off some of the other parts and make a little money back - I could get these axles pretty cheap.
Thanks all!
Hank
Of course - I'll try to provide any other information as I get it.