PDA

View Full Version : 8.8 flange



Jsk8r1
12-11-2006, 11:43 PM
Could somebody post up a link to where i could order the 1310 u-joint flange to adapt my rear drive shaft to the 8.8 disc flange. Ive looked and havnt found anything on where to order one even from people who have listed the part number for it. Would be much appreciated, thanks.

nate
12-12-2006, 12:03 AM
I think I have a spare one that I don't need. Interested?

chadjans
12-12-2006, 12:32 AM
Could somebody post up a link to where i could order the 1310 u-joint flange to adapt my rear drive shaft to the 8.8 disc flange. Ive looked and havnt found anything on where to order one even from people who have listed the part number for it. Would be much appreciated, thanks.

Just use a 1310 to 1330 conversion joint. They are cheaper than a new flange.

Jsk8r1
12-12-2006, 12:39 AM
Im not sure what you mean by the 1310-1330 conversion, arnt the stock u-joints 1310 on the ZJ rear drive shaft?

chadjans
12-12-2006, 12:49 AM
Go to Napa and tell them you need a 1310 to 1330 conversion joint. Cap OD is the same on both the 1310 and the 1330. A 1310 and 1330 differ by only cross length. A conversion joint has one leg of the cross that is 1310 length and the other is a 1330 length.

DJJordache
12-12-2006, 12:57 AM
precision ujoints part number 353 (what I did on my brothers 8.8 swap)

on mine I'm gonna use the flange adapter off a ~94-~97ish ford ranger rear dirveshaft already 1310. I got it last weekend offa 97 i think, it has a different part number than the spicer 2-2-1379 IIRC it was spicer 2-2-671 but I measured it and it has the same measurements as the 2-2-1379 so I'm gonna use that on my swap.

Jsk8r1
12-12-2006, 02:10 AM
Thanks guys, i hope to have my 8.8 completed and under the rig this coming up weekend.