View Full Version : Drivetrain
- driveshaft on 8.8 swap?
- D300 electronics
- Tranny pan bolt stripped
- Leaking tranny
- Axle swap questions??
- Help With Ebrake Kit (8.8/94 ZJ)
- cable shifter fab
- LOCKER
- 42RE
- 8.8 Limited Slip
- AW4 versus 42RE
- pinion angle 8.8?
- any tips for gear install on RR d44
- Check this out.
- 86 XJ front end
- 8.8 sway bar brackets?
- Oil pan skid questions for WJ
- Max tire size on locked d44a
- Dana D44A Service Manual PDF
- Clocking NP231?
- Severe breakage this weekend..
- From 249 to d300
- more 9" truss questions...
- Front Dana 44 or Alloy Dana 30?
- Quadradrive and Aussie Locker D44A
- D30 Shafts
- 231 swapped...
- HP D44/9"
- Help
- Build a free rear 60 or go find a 14b?
- pics of a flipped d300 install (zj)
- HP D60
- ARB solenoids........
- NV242 Question
- Problems installing my Aussie locker
- Questions before I regear
- hd231 to 241 roctrac swap question
- Spare shafts for al44
- ID this transfer case
- Double Cardan Rebuild
- Going Atlas II...and need some info...
- 8.8 drum to disc swap
- front end binding
- Questions about some axles
- Anyone bust an 8.8 shaft?
- D44 alloys
- Question on bent pinion gear
- lockright problems
- Speedo sensor (231HD -> 241 swap)
- Dana lockers?
- Merging OBDII and OBDI, also ECU vs seperate TCU
- Where is the latest hot place to buy unit bearings?
- 231 TC w/ SYE rear driveshaft length??
- Tranny Question
- Aftermarket Axle Interest with ABS??
- Need help removing rear axle bearing retainer (WJ)
- Alloys?
- AX-15 rebuild
- Transmission problems, need input please!
- Yota disc brake swap
- Going to 4.10s...
- D30 Diagram
- Interesting Axle information
- Quadradrive, and 4:56?? Is it possible?
- Aussie Locker Installed
- Quadradrive Aussie Locker Install....foiled again
- Axle swap and tone ring?
- ARB in QD D30
- Auburn Gear Ected Locker for D30??
- WJ --WMS?, Ford 8.8 ?? Axle build help.
- need advise
- EB Dana 20 Twin Stick Modification (T-shift)
- ABS tone Rings
- driveline noises
- 242 swap question
- Dodge D60 Unit bearing hubs convert to manual.
- 42RE swapability between years
- Axel Swap d30 question please help
- D30 Question
- Axle swap questions
- Transgo shift kit
- Best axle bracket kit for dana 44 front and ford 9" rear?
- Best years and make/model for D60's
- WJ replacement rotors
- Which T/C?
- different tcase input tech! promise =)
- To regear or not to regear
- Trans fluid
- gear swaps in 44a
- ZJ ABS Tone Rings
- anyone welded an 8.25
- Shift-Kit
- Installed Powertrax No-slip D35C Locker
- FYI....Guys with 8.8.....KILLER NEWS
- Cutting my axles down
- WJ rear axles
- Dana 44A 4.88 Gears?
- Pinion Angle Pics - Safe?
- 242 for 231
- front D30 from TJ
- D44 swap
- ford 8.8 v D44
- axles of Dana 44
- np 242 identification
- manual?
- 242 Swap ?
- any experience with Auburn Ected?
- Can it be so? 249 -242 swap
- need mounts
- REAR MAIN
- Cummins/Allison in a ZJ
- D30 pinion nut torque specs
- I know it's a long shot but...
- Motive gear experience?
- 1410 U-Joints?
- 8.8 axle housing
- Troubled 4.0 swap (please help)
- Quick Aussie Locker Question
- 242 vs. 231
- Exhaust..Headers
- input shaft spec's
- 8.8 Sway bar???????
- Transfer Case Drop
- 42RE to AW4 Swap 94 ZJ
- 242 Woes. GSW Aftermath
- ZJ front DS on a WJ???
- TJ axles and Warn Hubs
- Trouble with the 231 Swap
- Transmission leaks into T-case
- U-joints
- What do you think of my 9"?
- NP242 & NP 249 hybrid ?S
- Axles
- Driveshaft Help...
- Tom Woods DS vs local DS company
- Tom Woods Super Duty SYE?
- Rear 60 or 14b??
- d44-3.55 gears
- Help me decide
- Supper 8.8 Kit
- stick shift swap
- drive shaft question.
- Axle Applaction Question
- Need Pics 60s and 38s
- Best place to buy R&P 4.56 d44a
- pinion mate shaft stuck in 8.8
- u joint conversion on WJ
- Ever Have A 42RE Totally Crap Out?
- transfer case problems
- WJ ARB INSTALL(4.7 Tight fit)
- transmission swap/interchangability write ups?
- FYI, for those of you with D44a..
- Sterling 10.25-Inch Axle
- Short D300
- HPD30 information and gearing options
- 247 U-joint yoke.
- Hey 5spd Converts
- Ring gear selection
- Full Size Jeep transfercase question
- 14 bolt fitment
- Need basic axle swap info
- Atlas/d60s or 9
- To grind, or not to grind. (ring gear teeth)
- WJ axle shaft help
- Tranny Help!!!
- General gear install question
- D30 w/broken shaft stuck
- Case spreaders (DENVER)
- 5.13's with a 4.0
- NORTHTRAILS,found your Toner rings:CHEAP
- Anybody know of any performance tranny rebuild shops?
- Yukon axles and joint's
- Axle Dilemma.
- Homebrew D60
- Setting Pinion Angle?
- Axles to trade for a locke or two. Any interest?
- another 46RH blown
- trans/tcase swap from '93 4.0 auto to '96 5.2 auto
- Dana 44
- SYE for the NV247?
- I need help Identifying, this GM rear end! PICS!
- Front end trouble on the horizon?
- Crush sleeve or not?
- 249, 242 hybrid swaparoo
- came down on rock rear tranny output....
- WJ Axle swap
- Width?
- dana 44 spindle?
- 8.8 Cross Pin Bolt Removal
- 44a spool
- NV249-NV231D Input shaft swap?
- Transfer case linkage problems
- Any of you familiar with "The Fastman" parts?
- Axle bracket help
- 8.8 Locker
- AX-15 in obdII
- Flipped 300
- cummins 4bt into a ZJ??
- NV4500 to 360 V8, Starter Issues.
- TNT high clearance belly pan -NP231
- chromeoly shafts for WJ
- Waggy axle widths?
- '00 WJ 4x4 inop
- 249 to 231 input shaft sleeve
- Aussi locker in 44a WITH VARI-LOCK!!!
- doubler setups for your grand
- yota front axle swap
- front driveshaft questions
- Transmission line size??
- locker's f'd up
- AX-15 output shaft ghetto fab
- 60's Question on diff placement
- 2.5 jeep diesel swap
- fried ox locker cable
- HP44/60 combo
- T&T CUSTOMS D44 KIT
- Driveshaft Vibes? Maybe.
- New Grand Cherokee
- I want a 9"!!! Hybrid... Help! Looking for info a building a 9" rear axle!
- 231 swap
- Another 42re to AW4 swap thread
- Good idea for full float rear 9" or not?
- driveline brake
- Trussin' a 44a
- Trans swap ???'s
- 44re --> np242
- Driveshaft noob...would it work?
- 249 SYE available
- Have you seen a break like this?
- How much should i realistically set aside to build a 44a
- Transfer Case...
- Slip yoke install
- Slip yoke install
- Transfercase mode switch
- 242 question
- AW4 Tranny Breather Location
- hack and tap SYE
- B@M
- 4.0 to 5.2 swap
- R&P ratio differences between Dana and Ford differentials
- 8.25 in a ZJ?
- NVG241 in a Dub?
- Axle opinions
- Rebuilt 42RE?
- Beef the Dana 35 or Garbage it
- 3 channel ABS system for the GC
- brand new gears & brand new vibrations
- Pick my axle
- 8.8 is installed
- building up waggy 44's... got a (newbish) question
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.